User's Manual

Chapter Four Configuration
man_905_2.0.doc Page 37
4.3.2 Installation
Running from floppy disk
The software may be run directly from the distribution disk. If the software is to be used in this
manner, a copy of the distribution disk should be made, and the copy used to run the software.
Installing to a hard disk
Most users will want to install the configuration software to the hard disk of their computer. This
may be simply achieved by creating a directory on the destination hard disk and copying the
contents of the distribution disk to the hard disk.
For example, if the destination hard disk is drive C: and the distribution floppy is in drive A: the
following sequence of instructions may be used.
C:> MKDIR CFG105
C:> COPY A:\*.EXE CFG105
Hints for Windows Users
For slower machines, the software should be run in “Full Screen” and “Exclusive” mode under
Windows. If problems are experienced, exit windows and run the program from DOS.
4.3.3 Software Operation
Running from MS-DOS
Start the software by entering the directory where the configuration program is stored, and entering
the executable file name. For example, if the executable is stored in C:\CFG105 type the following
C:\> CD CFG105
C:\CFG105> CFG105-1 To configure a 905-1 module
C:\CFG105> CFG105-2 To configure a 905-2 module
C:\CFG105> CFG105-3 To configure a 905-3 module
and press the <ENTER> key.
Running from MS-Windows
Select the “Run...” option from the Start menu. In the Command Line Box type:
C:\CFG105\CFG105-1 To configure a 905-1 module,
C:\CFG105\CFG105-2 To configure a 905-2 module,
C:\CFG105\CFG105-3 To configure a 905-3 module,
and press the <ENTER> key.
The Initial screen will appear as below.