User's Manual

905U-E Wireless Ethernet Bridge User Manual

Man_905U-E Rev 1.0 Page 22

Fragmentation Threshold The maximum transmission unit (MTU) of data over the radio. This

selects the maximum number of bytes that will be transmitted in one

message. If more than this number of bytes is input into the 905U-

the module will transmit more than one message.

By default this level is set to 500 bytes

RSSI Threshold The received signal strength level at which beacons from Access

Points are to be ignored. This prevents Clients from establishing

links to Access Points beyond a sustainable range.

By default this level is set below the noise floor at -150 dBm.

Apply Changes Update settings in RAM.

Apply Changes and Save Update settings in RAM and save to non-volatile memory.

Filter Webpage Fields

Add Entries Enter the MAC addresses of devices to be added to the list. Multiple

entries must be separated by a semi-colon.

Delete Entries Check the box alongside entries selected for removal from the list.

Whitelist or Blacklist Uncheck the box to make the list a blacklist. This will ban all

devices with a MAC address in the list from communicating with the

905U-E or utilising the radio link.

Check the box to make the list a whitelist. This will only alow

devices with the MAC addresses listed to communicate with 905U-E

and utilise the radio link. All other devices are banned from

accessing the 905U-E and utilising the radio link. CAUTION: It is

important to add the MAC Address of the configuration PC

when creating a whitelist. If the configuration PC is not on the

whitelist, it will be unable to communicate with the 905U-E for

further configuration. It is advisable to use the Apply Changes

button to test the configuration entered. Once the configuration

is determined to be correct, the Apply Changes and Save button

should be used. In the event that the configuration is incorrect,

a power reset will revert the unit to previously saved

configuration.

Apply Changes Update settings in RAM.

Apply Changes and Save Update settings in RAM and save to non-volatile memory.

Serial Gateway Webpage Fields

This feature is not implemented in the beta release.