Manualshelf

User's Manual

ManualsBrandsELPRO Technologies ManualsElectronicsETHERNET RADIO MODEM
11121314151617181920
905U-E Wireless Ethernet Bridge User Manual
Man_905U-E Rev 1.0 Page 20
server is not secure, and should be disabled for normal operation of
the unit.
By default this is enabled.
MAC Address This is the unique hardware address of the 905U-E. This item is for
information purposes only.
This unique identifier is assigned to the 905U-E when built in the
factory.
Gateway IP Address The IP address of the default gateway.
By default this is set to 192.168.123.1.
Ethernet IP Address The IP address of the 905U-E on the RJ-45 ethernet port.
By default this is set to 192.168.123.123.
Ethernet IP Subnet Mask The IP network mask of the 905U-E on the RJ-45 ethernet port.
By default this is set to 255.255.255.0.
Wireless IP Address The IP address of the 905U-E on the radio port. If the unit is
configured as a bridge this address must be the same as the ethernet
IP address. If configured as a router, the IP address must be different
from the Ethernet IP Address.
By default this is set to 192.168.123.123.
Wireless IP Subnet Mask The network mask of the 905U-E on the radio port. If configured as
a Bridge, this must be the same as the Ethernet IP Subnet Mask.
By default this is set to 255.255.255.0.
System Address This field must be the same value for all 905U-E intended to interact
with each other using the radio. All units intended to operate within
the same radio cell must have the same system address configured.
By default System Address is set to “905E”.
Radio Encryption
Enabled
Check this field to enable encryption of data transmitted over the
radio.
By default Radio Encryption is disabled.
Encryption Keys 1 to 4 These are the keys used to encrypt radio data to protect data from
unwanted eavesdroppers. These keys must be set the same for all
905U-E intended to operate in the radio cell. Each of the fields are 5
bytes in length, and must be entered as hexidecimal numbers
separated by colons. Eg 12:AB:EF:00:56
Encryption keys must not be all zeros, ie 00:00:00:00:00
Save and Reboot. Save settings to non-volatile memory, and reboot 905U-E.