User's Manual

Elpro Technologies 450U-E Wireless Ethernet Modem & Device Server User Manual
Rev Version 1.0.12-Beta7 www.cooperbussmann.com/wirelessresources 21
Method 1 - Set PC to same network as 450U-E
Connect the Ethernet cable between unit and the PC configuring the
module.
Set the Factory Default Switch to the SETUP position. This will 
always start the 450U-E with Ethernet IP address 192.168.0.1XX,
subnet mask 255.255.255.0, gateway IP 192.168.0.1 and the radio
disabled. Do not forget to set the switch back to the RUN position
and restart the module at the conclusion of configuration for
resumption of normal operation.
Power up the 450U-E module. 

following description is for Windows XP - earlier Windows operating
systems have similar settings.

Select Internet Protocol (TCP/IP) and click on Properties. 
On the General tab enter IP address 192.168.0.1, Subnet mask 
255.255.25
Open Internet Explorer and ensure that settings will allow you to 
connect to the IP address selected. If the PC uses a proxy server,
ensure that Internet Explorer will bypass the Proxy Server for local
addresses.
This option may be modified by opening Tools -> Internet Options -> 
Connections Tab -> LAN Settings->Proxy Server -> bypass proxy for
local addresses.
Enter the default IP address for the 450U-E 192.168.0.1XX where XX

is the last two digits of the serial number.

Figure 22 Main Screen
Figure 20 - Local Area Connection
Figure 21 - TCP/IP Properties