User's Manual

Elpro Technologies E2-450 Radio Transceiver Module Instruction Manual
2 www.cooperbussmann.com/wirelessresources Rev Version
1.0
ATTENTION!
Incorrect termination of the supply wires may cause internal damage. Before turning the power on double-check ALL
connections by referring to this User Manual.
CAUTION
To comply with FCC RF Exposure requirements in section 1.1310 of the FCC Rules, antennas used with this device
must be installed to provide a separation distance of at least 20 cm from all persons to satisfy RF exposure
compliance.
DO NOT
 Operate the transmitter when anyone is within 20 cm of the antenna.
 Operate the transmitter unless all RF connectors are secure and any open connectors are properly
terminated.
 Operate the equipment near electrical blasting caps or in an explosive atmosphere.
All equipment must be properly grounded for safe operations. All equipment should be serviced only by a qualified
ELPRO staff only.
FCC Notice:
 Part 15 – This device has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part15 of the FCC rules (Code of Federal Regulations 47CFR Part 15). Operation is subject to the
condition that this device does not cause harmful interference.
 Part 90 – This device has been type accepted for operation by the FCC in accordance with Part90 of the FCC
rules (47CFR Part 90). See the label on the unit for the specific FCC ID and any other certification
designations.
Note: This device should only be connected to Devices that are covered by either a FCC DoC or
are FCC certified.
Antenna Models:
Manufacturer Model Number Coax Kit Net
ELPRO UDP400-3 Includes 3m Cellfoil 1dB Gain
ELPRO UDP400-5 Includes 5m Cellfoil Unity Gain
ELPRO BU-3/400 CC10/450 2.5dB Gain
ELPRO BU-6/400 CC10/450 5.5dB Gain
ELPRO YU3/400 CC10/450 3.5dB Loss
ELPRO YU6/400 CC10/450 6.5dB Gain
ELPRO YU9/400 CC20/450 5dB Gain
ELPRO YU16/400 CC20/450 10dB Gain