User manual

Page 68 915U-2 Wireless I/O
Page 68 User Manual
Figure 43 – Mesh Fixed Route #2 Routing Rules
Figure 43 shows the routing rules for the network diagram Figure 42- Mesh Fixed Route
#2” above
The first route shows the destination and next addresses are both 10.0.0.1 as it‟s a
single hop. Because the destination is a Gateway on an external network the IP
Gateway must be enabled.
The second routing rules shows the Destination (192.168.1.100) is an external network
and is outside of the radio mesh, therefore the External tick box must be enabled. The
next address will be 10.0.0.1, which is the IP Gateway.
Mesh Fixed Routing Rules
Name
A name that describes the routing rule (Max 32 characters).
Destination
The destination network or Host IP address. You can specify a
whole network by entering the IP range 192.168.0.0 with a
Netmask of 255.255.255.0 or specify an individual host IP
address.
Next
Specifies the IP address of the next hop router for the
specified destination. Next is the same as destination for the
final hop. Next is the same as destination for one-hop routes.
Hops
Indicates the number of routing hops to the destination.
IP Gateway
Indicates the Destination acts as a gateway out of the mesh
External
Indicates that it is routed through a Gateway outside of the
mesh
Enabled
Check this box to enable the rule. You can Uncheck the box to
disable a routing rule without needing to re-enter the
information at a later time.
Save Changes and
Activate.
Save changes to non-volatile memory, and restarting the
function to load new configuration.