User manual

915U-2 Wireless I/O Page 67
Page 67 User Manual
Figure 40 - Mesh Fixed Route #1
The Network Diagram above shows a typical network with mesh fixed routes. Normally
a meshing network will automatically learn the routes within a network and setup
appropriate communication paths to the destination. When manually configuring these
routes all communication paths need to be setup by using Mesh Fixed Routing Rules.
Figure 41 - Mesh Fixed Route#2 Routing Rules
Figure 41 above show the Mesh Fixed Routing Rules for the network diagram in Figure
40 above.
In fixed Route #1 it shows the Destination IP Address will be 10.0.0.1 and its Next hop
will be 10.0.0.2, there will be a total of 2 hops and the ”IP Gateway” and “External” are
un ticked as the destination will be the local I/O on 10.0.0.1.
In Route #2 is a route showing the communication path with repeater #2. The
destination and next addresses are both 10.0.0.2 because it‟s a single hop and again
the “IP Gateway” and “External” are un ticked as the communications is all local and not
through a Gateway or out of the mesh.
Example #2
Figure 42 - Mesh Fixed Route #2