User manual

915U-2 Wireless I/O Page 3
Page 3 User Manual
FCC Notice:
This 915U-2 module uses the “E2_900M Wireless Data Modem” radio and complies with
Part 15.247 of the FCC Rules.
Operation is subject to the following two conditions:
 This device may not cause harmful interference
 This device must accept any interference received, including interference that
may cause undesired operation.
915U-2 Radio Telemetry Unit must be installed in a suitable enclosure that provides
mechanical, shock and fire hazard protection.
This device must be operated as supplied by ELPRO. Any changes or modifications made
to the device without the written consent of ELPRO may void the user‟s authority to operate
the device.
This device must be installed by professional installers in compliance with 47 CFR Part 15
Subpart C Section 15.204 and 15.205, who will be responsible for maintaining EIRP no
greater than 36 dBm in accordance with 47 CFR Part 15 Subpart C Section 15.247 (b)(2)(4).
In accordance with 47 CFR Part 15 Subpart C Section 15.204 only the following
antenna/coax cable kits combinations can be used.
Manufacturer
Model Number
Coax Kit
Net
ELPRO
SG-900-6
CC10/900
5dBi Gain
ELPRO
SG-900-6
CC20/900
2dBi Gain
ELPRO
SG-900EL
CC10/900
2dBi Gain
ELPRO
SG-900EL
CC20/900
-1dBi Loss
ELPRO
YU6/900
CC20/900
4dBi Gain
ELPRO
CFD890EL
Includes 5m Cellfoil
Unity Gain
ELPRO
DG900-1
Includes 1m Cellfoil
-2dBi Loss
ELPRO
DG900-5
Includes 5m Cellfoil
-3dBi Loss
 Part 15 –This device has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part15 of the FCC rules (Code of Federal Regulations
47CFR Part 15). Operation is subject to the condition that this device does not cause
harmful interference.
 Notice – Any changes or modifications not expressly approved by ELPRO could void
the user‟s authority to operate this equipment.
This Device should only be connected to PCs that are covered by either FCC DoC or are
FCC certified.