User manual

915U-2 Wireless I/O Page 27
Page 27 User Manual
USB Host port
This port is a USB Host (Master port), which can interface with USB storage devices for
data logging (Future) and for upgrading the module Firmware – See section 4.3.6
“System Tools” for details on how this is done.
Dipswitches
The Dipswitches are used to select a number of functions within the module; the table
below indicates the different switch positions.
 Dipswitches 1 to 2 – Selection for measuring Current or Voltage on Analog Input
3. Set DIP switches ON to measure Current (0-20mA) and OFF for Voltage (0-
5VDC).
 Dipswitches 3 to 4 – Selection for measuring Current or Voltage on Analog Input
4. Set DIP switches ON to measure Current (0-20mA) and OFF for Voltage (0-
5VDC).
 Dipswitch 5 – DIP Switch not used
 Dipswitch 6 – When set to ON (Enabled), the module will boot up with a known
factory default including a default IP address for Ethernet connection. (Refer to
Chapter 4 - “Default ”)
Switch
Function
Current
Voltage
DIP 1 & 2
Analog Input #3
DIP 3 & 4
Analog Input #4
Switch
Function
Enabled
Disabled
DIP 5
Not used
DIP 6
Default
Configuration