User manual

User Manual
man_905K_1.10.doc Page 47
5.3.1 Read Inputs
This option provides a display of the
measured input signals in the 905K, both
internal and external. Digital inputs
(internal and external) are displayed as
"ON" or "OFF", the pulse input
accumulated count values are displayed
and the analog input value is displayed in
mA or V.
The displayed values will only update
when you select the “Update” box. Note
that the analog input value is only updated
when the configured analog sample
occurs.
If the analog display shows mA and you are using a voltage signal, then the analog input has not
been calibrated. Select the “…” box beside the analog display and follow the procedure in 5.3.3
below.
The counter values will display both base and Hi counters as a 32 bit number, but in “decimal”
format. If the counter value is less than 65536, then the Hi or overflow counter is zero.
5.3.2 Setting Counter Values
To manually set counter values, highlight the existing counter values and over-type the new
value required. Then select the green “3” box beside counter #2. The new values will be written