User manual

905U-G Wireless Gateway User Manual
Page 7©September 2004
4.2.2 Security 46
4.3 M
APPINGS 905G TO 905U I/O MODULES 48
4.3.1 Mappings from Inputs at Remote 905U I/O Modules 48
4.3.2 Mappings from 905G to Outputs at Remote 905U I/O Modules 50
4.3.3 Don’t Send if in Comm Fail 52
4.3.4 Startup Polls 53
4.3.5 Polls to Remote Modules 53
4.4 M
APPINGS FROM 905G TO OTHER 905G MODULES 53
4.4.1 Entering a Block Mapping 55
4.4.2 Host Device Trigger 56
4.4.3 Time Period 57
4.4.4 Real-Time 58
Change-of-State 60
4.4.6 Mixing Normal Mappings and Block Mappings 60
4.4.7 Comms Fail for Block Mappings 60
“Repeater-only” Configuration 61
4.5 C
HANGE SENSITIVITY 61
4.6 S
ERIAL CONFIGURATION - MODBUS 63
4.6.1 MODBUS Slave 63
4.6.2 MODBUS Master 65
4.7 S
ERIAL CONFIGURATION - DF1 68
4.8 F
IELDBUS CONFIGURATION 73
Fieldbus Mappings 74
4.9 F
IELDBUS CONFIGURATION - PROFIBUS SLAVE 79
4.10 F
IELDBUS CONFIGURATION - PROFIBUS MASTER 80
4.10.1 GSD File 80
4.10.2 Protocol and Supported Functions 80
4.10.3 Configuration 81
4.10.4 Message Interface 92
Error Codes 112
DPV1 Return Codes 113
4.11 F
IELDBUS CONFIGURATION - ETHERNET 113
4.11.1 Setting IP Address 114
4.11.2 Modbus TCP 116
4.11.3 EtherNet/IP 119
4.12 F
IELDBUS CONFIGURATION – DEVICENET 123
4.12.1 DeviceNet Introduction 123
4.12.2 DeviceNet Address Setting 123
4.12.3 EDS File 123
4.12.4 Protocol and Supported Functions 124
4.13 F
IELDBUS CONFIGURATION – MODBUS PLUS 124
4.13.1 Modbus Plus Introduction 124
4.13.2 Modbus Plus Addressing 124
4.13.3 Protocol & Supported Functions 125
4.13.4 Configuration 126
4.14 C
ONNECTING 105S SERIAL I/O 128
4.15 U
PLOADING AND DOWNLOADING 129
4.15.1 Loading from a 905G 129
CHAPTER 5 SPECIFICATIONS 131
CHAPTER 6 DIAGNOSTICS 133
6.1 DIAGNOSTICS CHART 133
6.2 D
IAGNOSTICS MENU 134
6.3 E
THERNET DIAGNOSTICS 141