User manual

905U-G Wireless Gateway User Manual
Page 141 ©September 2004
6.3 Ethernet Diagnostics
Read and Write
image array can also
be done via the
Ethernet port by
selecting ‘Debug
I/O Registers’ from
within the Ethernet
Settings window in
the configuration
software. The IP
address of the
module must have
previously been
configured in the
module - refer to
section 4.8.2 for
setting IP address.
To debug the
registers you will
need to select ‘Connect’ under Debug Options. The Green / Red box will indicate the
Connected / Disconnected State. Once connected select “Read” and check “Continuous”.
The display option allows you to view the registers in different formats, and you can select
which I/O register you want to view from the left-hand side of the screen.
Ethernet
diagnostics