User manual

Chapter Six Troubleshooting
man_905-105_2.9 Page 55
have to set up the connection parameters for future uses.
Connect the module (ensure the RS485 port is disconnected first) to the PC using the same serial cable
used for configuration. The diagnostics menu is accessed by setting all switches to ‘0’, and holding
down the red button for approximately 5 seconds, until the RX LED lights continuously. One of the
following menus will be displayed on the terminal :
105 V1.0
a) Ins
b) Tones
c) Comms
d) DO1
e) DO2
f) DO3
g) DO4
h) AO1
i) AO2
j) Switch
k) Signal
>
1052 V1.0
a) Digital Ins
b) Analog Ins
c) Tones
d) Comms
e) DO1
f) Switch
g) Signal
>
1053 V1.0
a) Ins
b) Tones
c) Comms
d) DO1
e) DO2
f) DO3
g) DO4
h) DO5
i) DO6
j) DO7
k) DO8
l) AO1
m) AO2
n) AO3
o) AO4
p) AO5
q) AO6
r) AO7
s) AO8
t) Switch
u) Signal
>
1054 V1.0
a) D Ins
b) A Ins
c) Tones
d) Comms
e) DO1
f) DO2
g) DO3
h) DO4
i) DIO1
j) DIO2
k) DIO3
l) DIO4
m) DIO5
n) DIO6
o) DIO7
p) DIO8
q) DIO9
r) DIO10
s) DIO11
t) DIO12
u) Signal
>
Choose an item from the menu by entering the letter before that item. For example, to select the
"Comms" function from the “-2” Menu, enter :- d
Inputs
This option provides a dynamic display of the status of all of the inputs in the 105, both internal and
external.
905U-1/105S-1 Modules
1234MLS P CNT AI1 AI2 P RATE VBATT
0101001 00F6 C000 4000 8000 9C00
The first 7 values (1234MLS) each represent a single digital input. A ‘1’ indicates that that input is
ON, and a ‘0’ indicates that the corresponding input is OFF. "1234" represents the four physical digital
inputs, DI1 to DI4. "M" is the mains fail status (‘1’ for mains fail, ‘0’ for mains OK). "L" is the battery