User manual

905U Wireless I/O Module User Manual
105S Serial I/O Module
Page 48 © October 2001
Programming Configurations to Modules
To program a module :
• Connect the cable
from the PC’s serial
port to the module
serial port (see 2.4.10
for cable connections)
• From the Utilities
menu, select “Serial
Port Setup”
• Select the appropriate
serial port (COM1 -
COM4)
• Select the unit to be
configured from the
left-hand menu
• Double-click
“Program Unit”.
Each module will need to be programmed individually.
4.3.3 Loading Configuration from a Module
Care should be taken when loading a configuration from a module. It is easy to lose the system address
and unit address. We suggest that you first view the system address and unit address - you can do this
via the “Unit Options” menu. Note these addresses before loading the configuration.
When you upload the configuration, the program will check if you want to load the addresses from the
module. If you do not, then the system address and unit address will change.
4.3.4 Print Options
You can obtain a print-out of each module configuration. On each unit display, there are “Unit
Summary” and “Mapping Summary” windows. Each of these will display a printable information page
about that module. The Unit Summary page will display the user options configured, and the Mapping
Summary will display the mappings entered for that unit.
The printer may be selected from the Printer Setup option in the File menu.