User manual

Chapter Five Specifications
man_905-105_2.9 Page 39
Loading configuration from an existing module
To load the configuration from a module, connect
the module to the PC via the RS232 cable and click on
“Load Unit”. This will allow you to view the module
configuration, change it, or copy it for another
module - refer to section 4.3.3 for more information.
Adding a new module to the system configuration
To add a new module to the system configuration,
click on “Units” on the left-hand menu and then “Add
Unit”. Select the type of module from the list.
Note that this program covers 105U, 105S and 905U modules.
These modules are essentially the same as far as configuration is
concerned. That is, a 105-1 or a 905-1 selection will configure a
105U-1, 105S-1 or a 905U-1.
The program will ask to select the unit address and will display
the list of available addresses for you to select. For 905U
modules, select an address between 1 and 95. For 105S
modules, select an address between 96 and 127.
The default name for a unit will include the unit address. For
example, “905-3#8” is a 905U-3 module with unit address 8
(and also 9, as a -3 takes two unit addresses). You can change
the name of a unit - for example, you could replace the default
name with “Pump Station 14”.
Deleting a Unit
A module can be deleted from the configuration by highlighting
the unit and selecting “Delete Unit”.