User manual

905U Wireless I/O Module User Manual
105S Serial I/O Module
Page 38 © October 2001
4.3.2 Program Operation
Start the software by either
clicking on the start bar and
navigating to the Configuration
menu or by running
ESERIES.EXE in the directory
selected in the setup stage.
The Initial screen will appear. The
configuration is performed for a
complete system. The necessary
configuration stages are :
" select system name and system
address
" select individual units and unit
addresses
" configure I/O mappings for
each unit
" configure user options for each unit
" load the configuration files into each unit.
From the initial screen, you can select an
existing project, or start a new project. The
name of the project will create a new directory
which will eventually contain the configuration
files for the modules in this system.
When you have selected the project, a screen
will appear where you may enter the system
address.
If you are editting an existing project, the
system address will already have been entered.
Do not change the system address unless you
are going to re-program all of the modules in
the system.
Double-click on the project name on the menu
on the left side of the screen. “Units” will
appear. You can now enter the types of units
which will be used in the system. If you
double-click on “Units”, then the modules that
have already been selected will appear.