User's Manual

Elpro Technologies 450U-E Wireless Ethernet Modem & Device Server User Manual
Rev Version 1.4.0 www.cooperbussmann.com/wirelessresources 25
 Default Gateway - This is the address that the device will use to forward messages to remote hosts that
are not connected to any of the local bridged network (Ethernet or Wireless). This is only required if the
wired LAN has a Gateway unit which connects to devices beyond the LAN - for example, Internet
access. If there is no Gateway on the LAN, set to the same address as the Access Point - that is, the
efer to section 3.10 IP Routing
2. Save Changes and Reset .
0U-E web page as shown in the
figure below with the correctly configured Model, Locale and Frequency.
General Configuration 3.4
Connecting to Existing Networks.
From the Main
menu as shown in Figure 27 - Right hand Menu.
Module Configuration can be viewed or modified by selecting each of the right hand heading.
Selecting each heading will open a new configuration page displaying configuration parameters
associated with that link.
The following sections explain each of the configuration pages.
When prompt user user
password (This is the factory default See section 4.11 Module Information Configuration
General Configuration Comments
A system of 450U-E must have at least one Access Point configured as a master with one or
more Clients.
All 450U-E
For further information and examples on wireless network topologies refer section 1.0 Network
Topology
The 450U-E supports two radio encryption methods, WEP128 and WPA2-PSK which can be
configured on the Security Page. The default encryption method is WPA2 and is setup during the
Quickstart process by simply entering a Password.
If utilising any form of encryption, all modules in the system will need the same encryption method
and keys. It is advisable to enter a new password and not use the The
available encryption methods are described in detail in Section 3.6 Security Menu below.
Figure 26 - Main Screen with Description
Figure 27 - Right
hand Menu