User's Manual

Elpro Technologies 450U-E Wireless Ethernet Modem & Device Server User Manual
22 www.cooperbussmann.com/wirelessresources Rev Version 1.4.0
Figure 22 - TCP/IP Properties
Set the RUN/SETUP Switch to the SETUP position. This will start the 450U-E with a default Ethernet IP address,

subnet mask, gateway IP address and the radio will be disabled. The default Ethernet address will be within the
IP range 192.168.0.1XX where XX is the last two digits of the serial number and should be shown on the label on
the back of the module. Do not forget to set the dip switch back to the
RUN position and restart the module at the conclusion of configuration.
Power up the 450U-E module. 

following description is for Windows XP - other Windows operating
systems have similar settings.

Select Internet Protocol (TCP/IP) and click on Properties. 
On the General tab enter IP address 192.168.0.1, Subnet mask 
255.255.25
Open Internet Explorer and ensure that settings will allow you to connect 
to the IP address selected. If the PC uses a proxy server, ensure that
Internet Explorer will bypass the Proxy Server for local addresses.
This option may be modified by opening Tools -> Internet Options -> 
Connections Tab -> LAN Settings->Proxy Server -> bypass proxy for
local addresses.
Enter the default IP address for the 450U-E 192.168.0.1XX where XX is 
the last two digits of the serial number.
Enter the default 
You should now be connected to the Locale Configuration page on the modem as per Figure 23 Locale Configuration
below.
You will now need to configure the modem with radio specification that conforms to the country of operation. Locale
Configuration below will explain this configuration process.
Figure 21 - Local Area Connection
Figure 23 Locale Configuration