User manual

Chapter 4 Configuration
Page 75 ©February 2009
The entry under “I/O Register” (see below) is the first I/O register in the 105G to be transferred -
the “I/O count” is the number of registers to be transferred.
The “Command Type” selected is a file write command (you can select read or write) - which
means that the values are sent from the 105G to the host device. The type of write command is
an “Integer” write, meaning that the register values will be written as register values.
The DF1 address of the host device (or “Slave”) is 2.