User manual

105G Wireless Gateway User Manual
Elpro_man_105g_1.18.doc Page 50
of the status register will be set to 1. The comms fail time should be more than the
corresponding update time at the remote input.
To set the comms fail times,
select the 105G, and select the
“Comms Fail Time” option.
Each remote input already
mapped to the 105G will
automatically be listed,
including the remote module
containing the mapping.
The default value for the
comms-fail time is “disabled”
or zero. To enter a time, select
the I/O register from the list.
The comms-fail time should be
greater than the update time of
the remote input.
Firmware version 1.76 and later:
The I/O value in the I/O registers can be reset to zero on
comms-fail. To enable this, select the enable box in the
“Comms Fail Times” configuration screen. Note that this is a global selection; comms-fail-reset
is configured on all registers or no registers.
4.4.2 Mappings from 105G to Outputs at Remote 105U I/O Modules
Mappings can be entered in the 105G to remote outputs. Select the “Mappings” option under the
105G. Select an I/O register and select the remote module and the output channel.
Select to reset
I/O registers