User manual

105G Wireless Gateway User Manual
Elpro_man_105g_1.18.doc Page 48
4.4 Mappings 105G to 105U I/O Modules
To transfer remote input signals to a 105G, or transfer a value to a remote output from a 105G,
you set up “I/O mappings”. You enter
mappings into the source unit, not the
destination unit. That is, you configure a
mapping at the “input” module. If you
want to transfer an input signal at a 105U
module to a 105G register, you enter a
mapping at the 105U I/O module. If you
want to transfer a 105G register to an
output signal at a 105U module, you enter
a mapping at the 105G module.
To configure mappings, double-click on
the module in the left-hand menu - the
menu will expand with selections for that
module. Select “Mappings”.
Each mapping comprises only one I/O
point. “Block Mappings” provide more
advanced communications between 105G
modules.
4.4.1 Mappings from Inputs at Remote 105U I/O Modules
Refer to the 105U I/O User Manual.