User manual

Chapter 4 Configuration
Page 47 ©February 2009
4.3.1 Loading from a 105G
If you load a configuration from a 105G into a “blank” or new project, then the program will not
be able to display the mappings from remote modules (as the program does not know what the
remote modules are). You will get a warning message like this:
If you open the archived project first, and load into the archived project, then all mappings will
display as normal - any mappings to/from the 105G will be over-written on the PC display by the
loading process.
If you are unable to load into the archived project, then mappings to remote modules will be
displayed, but mappings from remote inputs will be shown as “Unknown Mappings”.
If you also load the configurations from the other remote modules in the system, then these
unknown mappings will disappear as the program can determine where the remote inputs are.
Alternately, you can select “Link Mapping” and manually enter the remote inputs.