User manual

Chapter 4 Configuration
Page 43 ©February 2009
Loading configuration from an existing module
To load the configuration from a module, connect the
module to the PC via the RS232 cable, put the module
into “Configuration Mode” by pressing the
configuration button on the top end-plate, and click on
“Load Unit”. This will allow you to view the module
configuration, change it, or copy it for another module
- refer to section 4.3 for full details.
Adding a new module to the system configuration
To add a new module to the system configuration,
click on “Units” on the left-hand menu and then “Add
Unit”. Select the type of module from the list. For
105G modules, you will be asked to select the bus
protocol. This must match the 105G module type you
have installed.
You have the option of selecting a unit address for the
module, or allowing the program to select one
automatically. If you choose to select the unit address
the program will display the list of available addresses for you to select - valid addresses are 1 –
95.
The default name for a unit will include the unit address. For example, “105G#10” is a 105G
module with unit address 10. You can change the name of a unit - for example, you could
replace the default name with “Pump Station 14”.