User manual

105G Wireless Gateway User Manual
Page 165 ©February 2009
DisplayGateway
Syntax: <?--#exec cmd_argument=’DisplayGateway’-->
This function returns the currently used Gateway address
DisplayDNS1
Syntax: <?--#exec cmd_argument=’DisplayDNS1’-->
This function returns the address of the primary DNS server.
DisplayDNS2
Syntax: <?--#exec cmd_argument=’DisplayDNS2’-->
This function returns the address of the secondary DNS server
DisplayHostName
Syntax: <?--#exec cmd_argument=’DisplayHostName’-->
This function returns the hostname.
DisplayDomainName
Syntax: <?--#exec cmd_argument=’DisplayDomainName’-->
This function returns the default domain name.
DisplayDchpState
Syntax:
<?--#exec cmd_argument=’DisplayDhcpState( "Output when ON", "Output when
OFF")’-->
This function returns whether DHCP/BootP is enabled or disabled.
DisplayDhcpSupport
Syntax: <?--#exec cmd_argument=’DisplayDhcpSupport( "Arg1", "Arg2" )’-->
DHCP support can be disabled using configuration software. This function returns ‘Arg1’
if it’s enabled and ‘Arg2’ if it’s disabled.
DisplayEmailServer
Syntax: <?--#exec cmd: argument=’DisplayEmailServer’-->
This function returns the currently used SMTP server address.
DipslaySMTPUser
Syntax: <?--#exec cmd: argument=’DisplaySMTPUser’-->
This function returns the username used for SMTP authentication.
DipslaySMTPPswd
Syntax: <?--#exec cmd: argument=’DisplaySMTPPswd’-->
This function returns the password used for SMTP authentication.
GetText (Note - This function cannot be used within email messages)