User manual

Chapter 6 Diagnostics
Elpro_man_105g_1.18.doc Page 154
5. From this menu type the
letter corresponding to
“Initialize and Enter Debug
Menu” on the menu. (It may
be different for some
versions). This will then
display a “Debug Menu”
6. From this menu type the letter corresponding to “Enable Comms Logging”. (Again it
may be different on some versions).
7. Now click on “Stop Terminal” and then “Start Comms” and select whether you wish to
filter current system address. “Yes” for current system address only or “No” for all
System addresses.
8. Tick the “Time stamps” option and then select “Log to File” and type in the name of the
log file.
9. From now on everything that is received will be logged to this file with a time stamp.
10. The data frames can be
decoded by selecting a
message and then viewing
the panel below the
Terminal windows. (See
Below). You can see the
System address, Message
type, from and to addresses
as well as the data value,
which can be viewed in a
number of different
formats. I.e. Hex, Dec,
Analog and Digital.
To check firmware version