User manual

105G Wirless Gateway User Manual
Page 145 ©February 2009
To write to a register double click with mouse on the register
and a “Modify I/O Registers” pop up box will appear. Enter
value and press ‘OK’.
You can disable the links between the I/O registers and the
Ethernet interface by selecting “Disable Read Area” and
“Disable Write Area” - if you do this, remember to re-
enable before you leave the diagnostics screen.
Settings
You can change your TCP Connection setting i.e.
IP address and port.
Program / Load Unit
These options allow you to program and upload
the configuration from the module via the Ethernet
port. Must ensure the IP address has been set on
the module before uploading the Configuration
Monitor Comms
Configuration software also provides the option to monitor the radio network communications
via the Ethernet port. This allows radio traffic to be monitored from any location where an
Ethernet connection to the 105G can be established. Simply select ‘Monitor Comms’ from the
Network Debug Options section of the Ethernet Settings page. Functionality is as per section
6.2.2c above.