User manual

Chapter 6 Diagnostics
Elpro_man_105g_1.18.doc Page 144
6.3 Ethernet Diagnostics
Read and Write image
array can also be done
via the Ethernet port by
selecting ‘Debug I/O
Registers’ from within
the Ethernet Settings
window in the
configuration software.
The IP address of the
module must have
previously been
configured in the
module - refer to section
4.8.2 for setting IP
address.
To debug the registers
you will need to select
‘Connect’ under Debug
Options. The Green / Red box will indicate the Connected / Disconnected State. Once connected
select “Read” and check “Continuous”. The display option allows you to view the registers in
different formats, and you can select which I/O register you want to view from the left-hand side
of the screen.
Debug over
Ethernet