Specifications

Application Note 105U-G-PR2 Profibus Master
Issue 1.2 – May 2005
©ELPRO Technologies Pty Ltd
Page 2 of 13
app_105U-G_PR2_1.2.doc
comes with the Slave device (In this case the ET200S). This GSD file has the I/O map for the
installed Profbus Slave device and is needed by the software to workout what sort of I/O is
available and the addressing.
Next find the Slave device in the left hand tree window of the Profibus Network Configuration
window. Right click the device being used and select add to network or drag and drop the module
onto the network line as shown below. The module can only be added to the network line.
Next Double click on the Siemens ET200S (or other Slave device) to adjust available network
settings. See below.
This is were you can set the Profbus Slave address (Address will need to match the Profibus Slave
Device.