User's Manual

RF Transmission
433.92 MHz
Modulation
ASK (Amplitude Shift Keying of 433.92 MHz carrier)
Average
effective
radiated power
In motion: less than –35 dbm. Motionless: less than –45
dbm
Stability
+/- 20ppm
Peak ERP
-15 dbm (max)
Transmission
pattern
Omnidirectional
FCC compliance
FCC Part 15.231 Level C
Using the Equipment Tag with Input
The following is a set of procedures to ensure proper use of the Equipment Tag.
To use the Equipment Tag with Input:
1. Use some glue to attach the Equipment Tag to a piece of equipment.
2. A press button is available, if required.
3. Connect the two wires together to activate the input sensor.
Battery Replacement
The Equipment Tag contains a standard Lithium battery of type CR2032.
The battery is located inside the Equipment Tag. In order to replace the battery, you
need to open the back side of the equipment tag with a Phillips screwdriver
(preferably an electric one) with point size "0". For example, the APEX #4910. A new
battery can then be inserted, after which the screws must be replaced.