User's Manual

Using the Baby Tag
The following is a set of procedures to ensure proper use of the Baby Tag.
To use the Baby Tag:
1. Place the Baby Tag band around the baby's ankle.
2. Gently pull at both loose ends of wire until the strap is well wrapped (but not
tightened) around the baby’s ankle.
3. Hold the Baby Tag using two fingers of one hand, ensuring that the activating
set, comprising of the thumbscrew and hook, is held straight.
4. Close the thumbscrew.
5. Rotate the thumbscrew in a counterclockwise direction, as if closing a water
tap, until the lamp on the wall is switched on displaying a green light.
6. Cut excess loose wires.
7. Open the thumbscrew slightly and remove the activating set.
8.
Align the wire in the loop on the back of the tag, and snap the tag’s cover onto
the tag.