User's Manual

Elpas Personal Safety Bracelet – User Guide
www.elpas.com
Page 3 of 4
V3/Nov 2014
Tamper Lock Usage
Place the bracelet on the wrist of protected user as you would
any normal wrist watch.
Adjust the wrist band to snugly, but comfortably fit the wrist of the
intended user.
Thread the band tail through the band’s tamper lock. Ensure that
the tamper lock is as close to the band buckle possible.
Insert the Tamper Lock Key into the tamper lock. Turn the key
clockwise to secure the tamper lock into place on the wrist band.
If necessary, cut away the excess portion of the wrist band to that
the bracelet is more comfortable to wear.
Attaching the Conductive Band
Place the bracelet back cover side up. Then unscrew the 4
screws and remove the back cover
Position the bracelet front cover side down. Next insert the each
part of the band into the grooved slots which are located on
either side of the front cover.
Close the back cover such that the screw holes are correctly
aligned. Tighten the 4 screws snugly into place. Do not over-
tighten as this may strip the case threads
Cleaning & Disinfection Procedures
Use an appropriate antibacterial disinfectant such as Dispatch® Hospital Cleaner Disinfectant with Bleach from
Caltech Industries, Inc (http://www.caltechind.com) to clean the High-Risk Security Bracelet.
Since ‘Cleaning Procedures’ may vary according to facility guidelines, thus the procedures given below are for
illustrative purposes only:
Option 1 – Using Dispatch Disinfectant Spray
1. Lightly wet a disposable towel with Dispatch spray
2. Do not saturate the towel
3. Wipe the outer surfaces of the bracelet
4. Next wipe the bracelet with a dry disposable towel
5. Allow the bracelet to air dry
6. Return the clean bracelet to inventory or usage
7. Dispose of used towels per facility policies
Option 2 – Using Dispatch Disinfectant Towels
1. Open a new Dispatch pre-moistened towel
2. Wipe the outer surfaces of the bracelet
3. Next wipe the bracelet with a dry disposable towel
4. Allow the bracelet to air dry
5. Return the clean bracelet to inventory or usage
6. Dispose of used towels per facility policies