User's Manual

Elpas Curtain PIR Detector – Installation Guide
www.elpas.com
Page 2 of 8
V3/April 2013
Tamper Switch
The PIR Detector contains two spring loaded tamper switch that when
pressed, generates a ‘State’ message that is useful for registering the
detector in the host Elpas RTLS application.
(Refer to the Eiris Configuration Guide for enrolling transmitter IDs.)
Once registered, the tamper switch can also be used as an input trigger for
a device supervision tamper alert indicating non-authorized attempts to
remove the device’s cover.
Power
The PIR Detector derives its power from one CR2430 type lithium battery
(factory supplied).
IMPORTANT: The Wireless Input Module as well as all the input devices to be
monitored should be powered down when wiring in order to prevent accidental
shorts/spikes to cause damage to any of the devices.
Supported Event Transmissions
The Magnetic Contact Transmitter can transmit state changes from up to
two dry contact inputs (as a button press event message) to the host RTLS
server.
 Input 1 – Button 1 Event
 Input 2 – Button 2 Event
The input module can also transmit a state change from the tamper
switch (as a motion event message) indicating a non-authorized
attempt to remove the module’s cover.
 Tamper Switch – Motion Event
Note: Whenever a state change is detected the input module automatically
transmits 4 RF event messages 400ms apart with each transmission about 2ms
in duration).
FRONT
TAMPER
SWITCH
SENSOR
RANGE
SELECT
JUMPER
3 VOLT
LITHIUM
BATTERY
BACK
TAMPER
SWITCH
(OPTIONAL)
RF
MODULE
LEDS
Status Indicator
The Magnetic Contact Transmitter has a Red Status LED that
flashes once/second signaling either a low voltage condition or that
the device is transmitting.
Lithium Battery Installation (supplied with device)
Before inserting the CR2430 type lithium battery into the module’s
battery holder, confirm that the holes of the battery Isolator are
aligned with the contact pins. Then ensure that the positive (+) side
of the battery faces the PCB.
IMPORTANT: Inserting the 1/2AA battery improperly into the
battery clip may cause damage to the Wireless Input Module.
Product Specifications
Signaling Technologies
RF (433MHz)
Transmission Rate
Every 60 seconds
Device Inputs
1 analog dry contacts and one reed switch
Supervised Events
Low Battery, Tamper
Power Source
3.6V/1.2Ah Lithium Battery, LiSOCl2 size 1/2 AA
Average Battery Life
Approximately 3 years
LED Indicator
Low Battery, Device Transmission
Badge ID
Unique, factory-programmed ID
Construction
White polycarbonate plastic
Dimensions (H x W x D)
81 x 22 x 23.5 mm (3-3/16 x 7/8 x 15/16 in.)
Weight
Reed Switch (excluding battery): 34 grams (1.2 ounces) Magnet: 13 grams (0.45 ounces)
Operating Environment
Temp: 0°C to 49°C (32°F to 120°F) Humidity: 90% non-condensing
Remote Management
Eiris 4.8 (or higher) Elpas Configurator 4.8 (or higher) ELC Programmer V2.0
Standards
IC, FCC & CE compliant
Warranty
1 year limited warranty (excluding battery)
Product offerings and specifications are subject to change without notice. Not all products include all features
Preliminary