User's Manual

Elpas Local Controller 3 – Installation Guide
www.elpas.com
Page 4 of 6
V7/Jan 2015
Wall Mounting
The device (other than Outdoor ELC) is enclosed in an esthetic plastic box that facilitates installation. The box also provides tamper detection,
neat wiring which can come out of each side the user chooses, and optional antenna holes.
1. To open the front cover: Remove screws on the sides and then
place fingers in the opening groove of each side and push the
cover upward.
2. In case of cables that plug into wall sockets, open trunking
knockouts, with cutter or screwdriver, thread wires through the
opening(s), and plug into socket.
Note: Make sure the open trunking knockouts align with the socket.
3. Push tab to remove PCB and insert screws through rear cover and
the wall or ceiling.
4. Mount to wall or ceiling.
To mount onto a solid wall or ceiling, insert screws through the
corner holes of the base.
Note: Drill holes in the wall first.
To mount onto a drop-down ceiling: Drill screw holes in the tile,
insert screws through two of the rear cover middle holes, place the
ALC Bracket on top of the drop-down ceiling tile so its screw holes
align with the tile holes, and insert screws through the tile and
bracket.
5. Put PCB back into place.
6. To thread wires from the side, open the wire holes from any
direction (there is one on each side of the box), and the wire(s)
through the hole(s). Wrap any excess wire around the PCB.
7. Slide front cover into place and insert cover screws.