User manual

26
SYSTEM -Make changes to the system settings
Quit: Press this to properly shutdown the software and hardware
Reboot: Press this to Restart the software
Time & Date: Press this to change the time and the date. After adjusting the
time, press the SET TIME button to finish the setting and the time on the clock icon will be
updated simultaneously.
Settings:
Sys-manger is a hub where
the system settings reside and
lets you make changes over
the system.
In the wired network area, the networking can be done by plugging the broadband cable into
the RJ45 socket. Once the LED in the socket flashes, the networking is active. Then the IP
address can be assigned dynamically or manually. The dynamic IP address assignment is the
default setting, and the procedures of the IP address assignment are as follows:
Dynamic IP address assignment
<Step 1> Check on Dynamic in the column of IP and DNS, and
then the system will request the networking information from
the existing DHCP server (or a broadband router as a DHCP
server) and an IP address will be assigned from the server.
<Step 2> Press Activate” button, the connection will be
processed
<Step 3> The connect success” dialog will pop out. Press “OK”
button to finalize the settings.