Quick Install Guide

Remove stand cover using coin or
other tool. Remove the two screws
holding the rear portion of the stand
cover on and remove the cover.
Place pole mount on back of stand
and align the screw holes. Install
the (4) M4x14 screws to fasten the
stand and then replace the cover.
Partially install (2) M4x8mm screws
on top of monitor leaving gap to
hang monitor on slots of mount
plate. Install the other (2) M4x8mm
screws on bottom of monitor and
tighten all 4 screws.
Remove pole hinge cover and route
cables through pole and connect to
computer. Reinstall pole cover.