User Manual

User M
anual
–
IDS ET
320
3L/ET
430
3L
/ET5053L
UM600265
Rev
.
A, page
20
of
33
Example:
Have the monitor ON for Monday, Wednesday and Friday between 9:00AM and 5:00PM. All other days and time, the monitor shall
be OFF.
o Enable the On/Off Schedule
o Select M W F
o Set the ON time for 09:00:00 and the OFF time for 17:00:00
*Note that all of time settings operate on the 24-hour clock.
Wake-On-Touch
The touch display supports wake-on-touch functionality when the PC is in sleep mode. To enable this, please ensure that the BIOS settings
have enabled USB support during the S4 sleep cycle.
Intelligent Brightness Control and Color Sensor Functionality
This IDS Display includes a light and color sensor that can adjust the brightness of the screen and the color of the display to meet the ambient
light and color levels. Details of the functionality can be found in the Section 10, Appendix A.
The light sensor can be used to wake the monitor from sleep mode. This will happen when there is a change in the amount of light from very
dim (<50 lux) to bright (>200 lux). To enable this feature, ensure that the power saving mode for the monitor is disabled.
Energy Saving Mode
IDS ET3203L/ET4303L/ET5053L can meet Energy Star 8.0 requirements, if Energy Saving Mode is enabled.
When Energy Saving Mode is enabled, four side peripheral ports, MDC command and Auto Display Wake Up function will be limited. To
restore full functionality of the IDS Display, disable the Energy Saving Mode
ENERGY STAR is a program run by the U.S. Environmental Protection Agency (EPA) and U.S. Department of Energy (DOE) that promotes
energy efficiency.
This product qualifies for ENERGY STAR in the “factory default” settings and this is the setting in which power savings will be achieved.