User`s guide

Appendix B - The CTDIAG.CFG File CARROLL TOUCH
B-4 Touch System Diagnostics (CTDIAG) User’s Guide
Definition of Items
To define either a[LastFound] or [SearchListEntry] entry
type, use the following definition items. The default values are bolded.
• Interface Method: Direct, TAPI polling, TAPI interrupt.
• Controller type: HBC, serial (RS-232).
• Comm port: COM1, COM2, COM3, COM4.
• Baud rate: 300, 600, 1200, 2400, 4800, 9600, 19200, 38400,
115200.
• Parity: None, even, odd.
• I/O address: HBC address (200 - 3F0) (300H).
• Hardware interrupt: HBC interrupt (2, 3, 4, 5, 7).
• Software interrupt: TAPI software interrupt (50 - 70) (55).
The definition items you use to define an entry type will vary according
to the type of controller or interface method.
Serial (RS-232) Entry
The definition items used to specify a serial (RS-232) entry are:
• Interface method.
• Controller type.
• Comm port.
• Baud rate.
• Parity.
Any item not defined will use the default. If I/O address or hardware
interrupt are specified, they are ignored. To specify a non-standard
comm port address and/or interrupt, use the command line parameters
(Chapter 9) or the RS-232 Communication Parameters Menu (Chapter
4).
HBC Entry
The definition items used to specify an HBC entry are:
• Interface method.
• Controller type.
• I/O address.
• Hardware interrupt.
Any item not defined will use the default.