User`s guide

Chapter 9 - Command Line Options CARROLL TOUCH
9-4 Touch System Diagnostics (CTDIAG) User’s Guide
ctdiag N
Because no other parameters are specified on the command line, default
values are used. The command line equivalent of those defaults is:
ctdiag I:D C:R C1 B96 PE XL YT
Serial (RS-232) Controller
To start CTDIAG with a serial (RS-232) controller using COM2 and a
baud rate of 19200, type:
ctdiag C:R C2 B19200
CTDIAG uses the defaults of even parity and direct interface method.
Hardware-Based Controller (HBC)
To start CTDIAG with an HBC using I/O address 280H and hardware
interrupt 5, type:
ctdiag C:H A280 I5
CTDIAG uses the default interface method, which is direct.
To start CTDIAG with an HBC using hardware interrupt 5, type:
ctdiag C:H I5
CTDIAG uses the default of 300H for the I/O address.
TAPI Polling
To start CTDIAG with the TAPI polling interface method, type:
ctdiag I:P
The default software interrupt is 55H. RS-232 is the default controller
type; if the controller type is HBC, it is necessary to specify it by using
the C:H entry.
Non-Standard Installation
To start CTDIAG with a frame that has been mounted with the touch
origin on the right bottom corner of the screen, type:
ctdiag C:H A280 I5 XR YB