User`s guide

CARROLL TOUCH Chapter 9 - Command Line Options
Touch System Diagnostics (CTDIAG) User’s Guide 9-3
C: x = Specifies the controller type. x may be:
C = Software-based controller.
H = Hardware-based controller.
R = Serial (RS-232) controller (default).
X x = Specifies the origin of the x-axis of the touch screen. x
may be:
L = Left side (default).
R = Right side.
Y x = Specifies the origin of the y-axis of the touch screen. x
may be:
T = Top (default).
B = Bottom.
Note
Command line parameters are evaluated from left to right. For
example, if you type:
ctdiag n a2e8 i5 c1
COM1 is used instead of address 2E8H and hardware interrupt 5.
To display help for the command line parameters, type the following at
the DOS prompt:
ctdiag ?
Examples
Autodetection
To start CTDIAG with autodetection, type:
ctdiag
The CTDIAG.CFG file determines the search order for the touch
system. Since CTDIAG.CFG contains many commonly used
combinations of hardware and software parameters, this command can
usually determine the configuration of your touch system.
No Autodetection
To start CTDIAG without autodetection, type: