User`s guide

CARROLL TOUCH Chapter 6 - Touch System Information
Touch System Diagnostics (CTDIAG) User’s Guide 6-3
- Reporting Method: Coordinate reporting or scan reporting is
active.
- Touch Mode:
Tracking Mode
,
Continuous Mode
,
Exit Point
Mode
, or
Enter Point Mode
is active, with or without an Exit
Point Modifier.
- Touch Scanning: Touch system is not detecting (off) or is
detecting (on) touch.
- Report Transfer: Smart-Frame Protocol reports are not sent (off)
or are sent (on) to the host.
- Flow Control: Hardware handshaking is not used (off) or is used
(on) to regulate serial communications.
• Failed Beam Report identifies failed infrared beams and analyzes, if
possible, the cause. Information comes from the
Get_Failed_Beam_Report (36H)
command. This report is not valid
for guided acoustic wave touch systems.
For detailed information on these commands, refer to the
Touch System
Programmer’s Guide
.