User`s guide

Chapter 6 - Touch System Information CARROLL TOUCH
6-2 Touch System Diagnostics (CTDIAG) User’s Guide
To view system information for touch systems, take the following steps:
1. From the Test Configuration Menu (Figure 3-1), press ENTER to
display the Test Menu.
2. Select System Info from the Test Menu (Figure 4-1). The System
Information screen, shown in Figure 6-1, appears.
Figure 6-1. System Information Screen
This screen reports the results of various commands in the Smart-Frame
Protocol.
• Processor Errors identifies the current error conditions. Information
comes from the
Get_Error_Report (32H)
command.
• Configuration Report reports the number of processors, and their
identifiers, in the touch system. Information comes from the
Get_Configuration_Report (33H)
command.
• Firmware Version Report is a list of the firmware versions for the
various touch system components. Each version is a 10-byte
ASCII-encoded string. Information comes from the
Get_Firmware_Version_Report (34H)
command.
• Frame Size Report describes the frame size of the infrared touch
system in both logical (x, y) coordinates and physical beams. It is
based upon the
Get_Frame_Size_Report (37H)
command. This
report is not valid for guided acoustic wave touch systems.
• State Report lists the current settings for regular coordinate
reporting, based upon the
Get_State_Report (47H)
command.
Definitions of most of these parameters are contained in Chapter 5.
The flags include: