User`s guide

Controller Data Sheets 35
AccuTouch PC-Bus Controller (E271-2201)
Verify the controller’s jumper settings are as follows:
(From Top)
Default from jumpers J7 - Y
Reserved J6 - N
Touchscreen Type
AccuTouch J5 - Y
Stream Mode J4 - N
No Interrupt (software selected) J3 - N
J2 - N
Base I/O Port (in hex)
280 (recommended) J1 - N
J0 - N
240 J1 - N
J0 - Y
180 J1 - Y
J0 - N
100 J1 - Y
J0 - Y
2A0 Cross-connect (connect jumper vertically so
the left pins of J0 and J1 are jumpered)
J10 and J11 elsewhere on the controller should not be jumpered.
Jumpers cross-connected vertically on the right side of the jumper block have no
effect and are available as extra jumpers.