User`s guide

25
$SSHQGL[$
Configuring Your Controller
•
General Information
25
•
Controller Data Sheets
26
G
ENERAL
I
NFORMATION
This appendix describes how to configure your controller’s switch and/or jumper
settings for use with MonitorMouse for OS/2. Controllers are typically shipped
pre-configured for use with MonitorMouse for OS/2.
Your controller’s switch and jumper settings can be found on one of the next few
pages. Our recommendations should give you the best performance, but feel free to
try other settings if an option is given.
For controller drawings and installation instructions, refer to the IntelliTouch
Product Manual or the AccuTouch Product Manual.
Choosing an Interrupt (IRQ) for PC-Bus Controllers
MonitorMouse for OS/2 requires all PC-Bus controllers to be in Interrupt Mode.
Choose the interrupt (IRQ) carefully so it will not conflict with another device
installed in the system.