User`s guide

8 Chapter 2 - Installing MonitorMouse for OS/2
Step 1 Configure your controller
Step 2 Copy the software
Step 3 Modify CONFIG.SYS
Step 4 Install the Touchscreen Control Panel
Step 5 Calibrate the touchscreen
S
TEP
1 - C
ONFIGURE YOUR
C
ONTROLLER
Verify your controller configuration using the setup instructions provided in
Appendix A. Elo typically ships touchscreen controllers preconfigured for use with
Elo software, including MonitorMouse for OS/2. Configuration requires setting
switches and/or installing jumpers that determine controller operating parameters.
You will need these parameters when you install the MonitorMouse for OS/2
driver software.
For controller installation instructions, refer to the IntelliTouch Product Manual or
the AccuTouch Product Manual.
S
TEP
2 - C
OPY THE
S
OFTWARE
The following files are on the MonitorMouse for OS/2 disk:
!READ.ME! Text file containing any additions or changes
made after this manual was printed.
MONMOU01.SYS Touchscreen driver for serial touchscreen
controllers on PC-Bus systems.
MONMOU02.SYS Touchscreen driver for serial touchscreen
controllers on Micro Channel systems.
MONMOU03.SYS Touchscreen driver for PC-Bus and Micro
Channel touchscreen controllers.
ELOCAL2.EXE Touchscreen Control Panel used to calibrate
the touchscreen and select options.
ELOCAL2.DLL Used by ELOCAL2.EXE.
ELOCAL2.HLP Help file for ELOCAL.EXE.
ELO.BMP Elo desktop wallpaper.
@6253.ADF Description File for the E271-2202 Micro
Channel touchscreen controller.
COMDUMP.EXE DOS program for testing serial touchscreen
controllers.
BUSSTAT.EXE DOS program for testing PC-Bus touchscreen
controllers.
SAWDUMP.EXE DOS program for testing IntelliTouch touchscreen
controllers.