User Guide

Elo TouchSystems 2240L User Guide 34
B) Notice to Users in Canada: This equipment complies with the Class
B limits for radio noise emissions from digital apparatus as established
by the Radio Interfer ence Regulations of Industry Canada.
C) Notice to Users in the European Union: Use only the provided
power cords and interconnecting cabling provided with the equipment.
Substitution of provided cords and cabling may compromise electrical
safety or CE Mark Certifi cation for emissions or immunity as required
by the following standards: This Information Technology Equipment
(ITE) is required to have a CE Mark on the manufacturer’s label which
means that the equipment has been tested to the following Directives
and Standards:
This equipment has been tested to the requirements for the CE
Mark as required by EMC Directive 89/336/EEC indicated in European
Standard EN 55022 Class B and the Low Voltage Directive 73/23/EEC
as indicated in European Standard EN 60950.
D) General Information to all Users: This equipment generates, uses
and can radi ate radio frequency energy. If not installed and used ac-
cording to this manual, the equipment may cause interference with
radio and television communications. There is, however, no guarantee
that interference will not occur in any particular installation due to site-
specifi c factors.
1) In order to meet emission and immunity requirements, the user
must observe the following:
a) Use only the provided I/O cables to connect this digital
device with any computer.
b) To ensure compliance, use only the provided
manufacturer’s approved power cord.
c) The user is cautioned that changes or modifi cations to
the equipment not expressly approved by the party
responsible for compliance could void the user’s authority
to operate the equipment.
2) If this equipment appears to cause interference with radio or
television reception, or any other device:
a) Verify as an emission source by turning the equipment
off and on.
b) If you determine that this equipment is causing the