User Guide

MAG-TEK, Inc.

Printed in the United States of America

Information in this document is subject to change without notice. No part of this document may

be reproduced or transmitted in any form or by any means, electronic or mechanical, for any

purpose, without the express written permission of Mag-Tek, Inc.

MagTek is a registered trademark of Mag-Tek, Inc.

Microsoft, MS, MSDOS, MSCOMM and Microsoft Visual Basic are registered trademarks of

Microsoft Corporation; Windows and Windows 95 are trademarks of Microsoft Corporation.

REVISIONS

Rev

Number

Date Notes

1 20 Nov 98 Initial Release

2 16 Feb 99 Sec 1: Editorial comments for clarification; Sec 2: Added c_wr_secure

and trks 1, 2, and 3; Sec 3: Editorial comments for clarification;

Appendix A: Added MT-85 and clarified tables; Appendix D: Added

c_wr_secure and tks 1, 2, and 3 and MT-85 Encoder sheet.

3 27 Apr 99 Global: Changed names of Mt-211 and MT-215 to port powered

readers; Sec 3: Added card insertion note to event; Sec 4: Added this

section, Data Parsing. Appendix A: Changed file names. Appendix D.

Changed names.

4 21 Oct 99 Sec 1: added: part numbers of media, special commands, MICR

material; Sec 2: changed properties table; Sec 3: added errors 45 and

60 to write command; Sec 4: added descriptions to language format;

updated default formats; Sec 5: replaced Visual Basic example;

Appendix A; Completely revised; Appendix D: added applied_fmt to all

forms.

5 14 Dec 99 Appendix A: Added statement about "Long File Names" under "Adding

MagTek Device Drivers" General Notes number 4; added statement to

"Completing the Installation" about sharing a single port; Edited

"Removing the Drivers"; added "Configuration Examples of NT Drivers."

Appendix D: Under IntelliPIN PINPad and MSR, added statement under

Remarks about IntelliPIN driver; under MiniWedge MSR added

statement about ASCII and Character Conversion.

6 30 Nov 01 Editorial changes throughout and added Software Version MTD 1.10,

which includes Windows ME/2000/XP.