User Guide

2-19

Accessing the VESA Mounting Interface

If you want to convert your desktop monitor to a wall mount or kiosk monitor,

follow the steps below to access the VESA mounting interface.

OTE

You will need a screwdriver for the following steps.

1 Remove the back cover of the stand by pulling forward on the bottom

cut-out.

2 Carefully lay the monitor face down. At the top of the mounting screw cover

there are two slots. With a screwdriver, pry open the mounting screw cover.

The cover fit is tight so remove it carefully.

3 When you remove the mounting screw cover, you will see four screws.

Remove the screws to mount your monitor. Refer to the drawing on page 18.

The following companies provide VESA mounting devices compatible with

your touchmonitor:

Mounting the Base

You can also mount your touchmonitor by using the keyholes in the base of the

stand. These keyholes provide easy slide on mounting. You can also bolt your

touchmonitor to a tabletop or other flat surface. Please refer to Appendix C for

location and dimension of the mounting holes.

Ergotron

800-888-8458

651-681-7600

www.ergotron.com

Innovative Office Products

800-524-2744

610-253-9554

www.innov-office-prod.com

GCX

800-228-2555

707-773-1100

www.gcx.com

MRI

800-688-2414