Product manual

4-42 Elo Entuitive Touchmonitor
Figure 4.3 Rear View of an AccuTouch Touchscreen with Mounting Materials
Before mounting the touchscreen, clean the face of the monitor and the back of
the touchscreen with household glass cleaner. Be sure to remove all
fingerprints. The space between the touchscreen and the monitor face must be
clean and free of any foreign objects.
Mount the touchscreen as follows:
• Use two layers of the double-sided adhesive tape to achieve a total thickness
of 1/16-inch (2 mm). While specific touchscreen and CRT combinations may
allow the use of thinner materials, 1/16-inch (2 mm) is generally necessary to
allow for variations in ROC between the two glass surfaces. Review the fit
between the touchscreen and the CRT before applying the tape. If one pair of
opposite edges has a closer fit than the other, put the adhesive tape on the
edges of the touchscreen with the better fit. See figure 4-2 for typical
placement. If there is a good fit on all four edges, you may want to use
double-sided adhesive tape on all four edges. When doing this, move the
adhesive tape in slightly on one pair of edges and add foam sealing tape
outside these two edges. The thicker foam tape will keep the adhesive tape
away from the CRT until you are ready to adhere the touchscreen to the
monitor.
In general, the adhesive tape should be set back slightly from the edge of the
active area of the touchscreen. When the monitor is reassembled, the
mounting tape should not be visible. Do not remove the liner from the
exposed side of the adhesive tape yet.