Specifications

AE/LZB 119 1897 R1A SOFTWARE CONFIGURATION

6.3.2.2 Dial-Up Line Configuration (Typical)

As previously stated, dial-up line modem links require manual establishment of the connection. Normally, this is

accomplished with the Windows NT Terminal program (TERMINAL.EXE) followed by start-up of the console application.

The following list is an example of the modem configuration required for each modem in a dial-up line modem link

employing U.S. Robotics Courier V.32 bis Turbo modems. Refer to the modem manufacturer’s documentation for additional

information:

US Robotics Courier V.32 bis Turbo Settings...

B0 C1 E1 F1 M1 Q0 V1 X1

BAUD=9600 PARITY=N WORDLEN=8

DIAL=PULSE ON HOOK TIMER

&A1 &B1 &C1 &D0 &G0 &H0 &I0 &K0 &L1 &M5 &N0

&P0 &R1 &S2 &T5 &X0 &Y1 %N6

S00=001 S01=000 S02=043 S03=013 S04=010 S05=008 S06=002 S07=255

S08=002 S09=006 S10=007 S11=070 S12=050 S13=000 S14=000 S15=032

S16=000 S17=000 S18=000 S19=000 S20=000 S21=010 S22=017 S23=019

S24=150 S25=005 S26=001 S27=000 S28=008 S29=020 S30=000 S31=000

S32=000 S33=000 S34=000 S35=000 S36=000 S37=000 S38=000 S39=000

S40=000 S41=000 S42=126 S43=200 S44=015 S45=000 S46=000 S47=000

S48=000 S49=000 S50=000 S51=000 S52=000 S53=000

----------------------------------------------------------------------------

DIP Switch (both modems in a pair)

Sw 1: Up = DTR Normal Sw 6: *Up = Normal Carrier Detect

*Dn = DTR Always On Dn = Carrier Detect Override

Sw 2: Up = Verbal Result Codes Sw 7: Up = Display All Result Codes

Dn = Numeric Result Codes Dn = Result Orig. Mode Only

Sw 3: *Up = Suppress Result Codes Sw 8: *Up = Disable AT Command Set

Dn = Display Result Codes Dn = Enable AT Command Set

Sw 4: Up = Echo Offline Commands Sw 9: Up = Disconnect with +++

*Dn = No Echo Offline Commands Dn = No Disconnect with +++

Sw 5: *Up = Auto Answer on Ring Sw 10: Up = Load NVRAM Defaults

Dn = Suppress Auto Answer *Dn = Load Factory Settings

*Switch must be in this position