Specifications

SOFTWARE CONFIGURATION AE/LZB 119 1897 R1A
63
6.3.2 U.S. Robotics Courier Modems
6.3.2.1 Dedicated Line Configuration (Typical)
The following list is an example of the modem configuration (status register values, etc.) required for each modem in a
dedicated line modem link employing U.S. Robotics Courier V.32 bis Turbo modems. Refer to the modem manufacturer’s
documentation for additional information such as cable hook-up and DIP switch configuration requirements. Also refer to
LBI-33031.
US Robotics Courier V.32 bis Turbo Settings...
B0 C1 E1 F1 M1 Q0 V1 X1
BAUD=9600 PARITY=N WORDLEN=8
DIAL=PULSE ON HOOK TIMER
&A1 &B1 &C1 &D0 &G0 &H0 &I0 &K0 &L1 &M5 &N0
&P0 &R1 &S2 &T5 &X0 &Y1 %N6
S00=001 S01=000 S02=043 S03=013 S04=010 S05=008 S06=002 S07=255
S08=002 S09=006 S10=007 S11=070 S12=050 S13=000 S14=000 S15=032
S16=000 S17=000 S18=000 S19=000 S20=000 S21=010 S22=017 S23=019
S24=150 S25=005 S26=001 S27=000 S28=008 S29=020 S30=000 S31=000
S32=000 S33=000 S34=000 S35=000 S36=000 S37=000 S38=000 S39=000
S40=000 S41=000 S42=126 S43=200 S44=015 S45=000 S46=000 S47=000
S48=000 S49=000 S50=000 S51=000 S52=000 S53=000
----------------------------------------------------------------------------
DIP Switch
Sw 1: Up = DTR Normal Sw 6: *Up = Normal Carrier Detect
*Dn = DTR Always On Dn = Carrier Detect Override
Sw 2: Up = Verbal Result Codes Sw 7: Up = Disp. All Result Codes
*Dn = Numeric Result Codes *Dn = Result Orig. Mode Only
Sw 3: *Up = Suppress Result Codes Sw 8: *Up = Disable AT Command Set
Dn = Display Result Codes Dn = Enable AT Command Set
Sw 4: Up = Echo Offline Commands Sw 9: Up = Disconnect with +++
*Dn = No Echo Offline Commands *Dn = No Disconnect with +++
Sw 5: Up = Auto Answer on Ring (CIM) Sw 10: *Up = Load NVRAM Defaults
Dn = Suppress Auto Answer (PC) Dn = Load Factory Settings
*Switch must be in this position
Note: SW3, SW4 and SW10 may have to be temporarily changed to program modem NVRAM
via PC. Settings should be saved in NVRAM with &W command.